These tungsten buffer weights are made from aerospace grade tungsten! Simply replace the stock weights with the new tungsten weights for improved stability.
THREE PACK OF WEIGHTS
- DENSE, heavy, high quality replacement for your stock rifle buffer weight. Perfect for your AR-15
- PERFORMANCE specs: 0.55" dia. x 0.612" long, 1.43oz each (3-pack)
- UNITED STATES based manufacturing & customer service staff are here to help you
- SAFE to handle and completely non-toxic cylinders are more dense than lead, steel, or aluminum
- FREE shipping
Tungsten is one of the densest naturally occurring elements, and now you can add one of nature's wonders to your own collection. If you like the tungsten buffer weights, don't forget to check out our tungsten cubes and spheres.
31 Reviews Hide Reviews Show Reviews
Did exactly as expected. Perfect fit and finish. All three weighed exactly the same. Would certainly purchase again for my next AR 15 build.
No problem, good value. Use them to do ---3.8...0r 4.8 oz . weights.
Just what the Dr. ordered. Fast shipping good company will buy again.
Perfect one-for-one replacements in my stock rifle buffer. Cylinder to cylinder weight variation is extremely low.
These weights are just what one needs to tune a standard buffer into slower opening and softer recoiling HB, 2HB, or 3 HB. One set of three tungsten weights allows you to replace the internal steel weights with one to three tungsten weights tuning the buffer to your needs perfectly, all at a fraction of the cost of buying three separate buffers. Buying a HB, 2 HB, and 3 HB buffer can easily cost you $80 to $100, depending on from who you buy, but one set of these weights allows you to get the buffer weight you need for less than $30. How can one argue with that unless you are so inept with tools that you cannot change your own buffer internals. In that case, maybe it's best you buy factory made heavy buffers. HINTS: Mark polymer buffer end and body with a Sharpie making witness marks. The holes often do not line up if you put it back together 180* off. Drive out the roll pin with a roll pin punch. Using a new set of QUALITY side cutting pliers, grip the polymer buffer and wiggle it out of the body. A set of used pliers with worn gripping surface will only chew up the polymer buffer. I keep a new set of Kleins to be used expressly for this use. Change out the internals. Put some light grease or oil on the polymer buffer and slide it back together, aligning the witness marks you made. Use a punch to slide through the buffer and body to make sure the holes are aligned on both sides. Use a roll pin starter to start the roll pin back into the hole in the body and finish with a roll pin punch or you can even squeeze the pin back in with a bench vice, then tap the pin flush with the body with a brass hammer. Do not go bat-crap crazy with the vice or hammer and damage the body. You get no points for proving how much hair you have on your chest.
The weights weigh the stated amount, are the correct size to fit in a buffer, and are competitively priced.
Perfect Quality.... fast shipping... now I have all 3 buffer weights H, H2, & H3.. I'm all set... Woo Hoo.... bought the 6 pack what a deal.. Thanks
These weights are just what I was looking for. I plan on using these to convert standard carbine buffers to the H1 style buffers. The weights where nicely packaged and over all look very nice. Once I covert my first buffer I will know if they will do what I want.
These are made very precisely; beautiful finishing, consistent, and are really priced VERY reasonably. They're now my go-to source if I need to customize a buffer weight. Why buy a whole buffer when you can customize yours for a lot less? The turn-around time is phenomenal.